How To Repair A Leaking Faucet?

Are you dealing with a leaky faucet at home? Not only is a dripping faucet annoying, but it’s also a waste of water. Leave it alone for too long, and your leaking faucet could also turn into a bigger problem. 

If you’re finding it difficult to find certain replacement parts, you should consider replacing the entire faucet instead of fixing it. Replacing a faucet that’s leaky or outdated isn’t too tricky, and you can tackle this project with some basic tools such as a basin wrench. This repair should also take no more than an hour. Here’s how you can repair a leaking faucet.

Easy steps for fixing your faucet

Luckily, fixing a leaky faucet is both inexpensive and straightforward because unfortunately, leaky faucets are among common plumbing problems that homeowners often find.

Even if you’ve got no DIY experience, you shouldn’t feel intimidated by the process. All you’ve got to do is follow the steps listed below, and you’ll see how easy it is to replace the faulty parts and get the situation under control. 

Step 1: Shut off the water 

To start, you’re going to want to turn off the entire water flow. While you can do this by twisting the valve under your sink, you can also shut off the whole house’s water supply. Once the water supply has been turned off, you should turn on the faucet until the water stops running.

Step 2: Remove the handle

Then, you’re going to remove the set screw that’s situated behind the handle. You can do this with either a hex wrench or a small screwdriver. Once the set screw has been removed, go ahead and lift off the handle and remove the dome housing. You’ll also be able to remove the cylinder that contains the disks. 

Step 3: Get the replacement parts 

Once you have the cylinder, you can also pry out the O rings with your fingers. Depending on the model of your faucet, removing the bottom plate will also reveal some rubber seals. Remove them carefully. 

Then, check to see if the cylinder is cracked. If so, you’ll need to replace it. Most of the time, you’ll only need to replace the O rings. Other times, you may need to replace other items such as the cartridge, stem, or ball. Take these items with you to your nearest hardware store to find replacement parts. Keep in mind that both the O ring and the cylinder come in different shapes and sizes, so you need to make sure you’re purchasing the right one. 

You should also check the brand name of your faucet before heading to the store as there’s usually a repair kit brand to match. If you’re not sure, it may be wise to take the whole faucet with you to the store. You can also head to a plumbing supply store to have a competent sales individual assist you with your needs. 

Step 4: Clean the parts thoroughly 

Before replacing the parts, gently clean away any scum and debris using a toothbrush. You’d also want to rub some silicone grease on the rubber parts. 

Step 5: Assemble everything 

Once you’ve gotten all the parts and cleaned the area, go ahead and reassemble the cylinder – make sure that it’s facing the same direction as before. Once you’ve reassembled the cylinder, slowly turn on your faucet to check if everything’s good to go.

Summing up

If your faucet still continues to drip or you’ve got water leaking below the sink, it could be due to an issue with the stop valve or supply tube. In such instances, it’s best to call either a professional plumber or plumbing service to help you out with the job. 

Not only do they have the expertise to help with troubleshooting the problem, but they’ll also prevent any further issues from occurring in the long run. If your home is on the older side, make sure you find out what kind of homeowners insurance policy you should consider. Get in touch with Professional Plumbing NSW if you need a hand with fixing your leaking faucet today.

Leave a Reply

Your email address will not be published. Required fields are marked *